Pendlay Elite Squat Stand with Pull Up Bar

Optional Equipment
	0-90 Adjustable Bench [+$329.00] Flat Weight Bench [+$179.00] Weight Horns (pair) [+$79.00] Safety Arms (pair) [+$109.00] Dip Attachment [+$119.00] Extra Pair of J-Hooks [+$49.00]

Quantity

Email a friend

Add to Wish List

Description

The Pendlay Elite Squat Stand with Pull Up Bar is constructed with 2 x 3 x 11 gauge rectangle tubing with 17 possible latch locations. Solid construction allows for a very long life span. A 1-1/4" pull up bar 95" located from the ground. Bar is powder coated with a fine texture to add grip while not being rough on the hands. The uprights are strategically placed to give optimum balance whether doing pull ups or dips with the optional dip attachment. The industry leading J latch is simple yet sturdy and is covered in UHMW inside and out in order to limit metal to metal contact, thus insuring the look of the stand for years. A pair of J latches come with the squat stand. Single piece construction. No plastic end caps, all caps are metal and welded. Footprint is 48" wide, 46" deep, 95" high and it weighs 105lbs with no attachments.

Optional Equipment

Pendlay Elite 0-90 Adjustable Bench - The Pendlay Elite 0-90 Adjustable Bench is a ladder backed without pop pins for adjustment. Seven positions are available; 0, 30, 40, 45, 60, 75, and 90 degrees. This is acheived by three ladder positions for the back pad and two adjustable positions for the seat pad. The final position is 0 degrees, both pads flat. All benches come with two wheels for easy movement and 2" x 3" rubber feet for maximum floor protection and stability. Each pad is made of 2 1/2" high density foam. Wide rear base for optimal lifting stability and front base is shorter for less foot interference.

Flat Weight Bench - Single piece construction, ships fully assembled.

Weight Horn Attachments (pair) - The weight horn attachments are a versatile tool that can be used for general weight storage or to place weights on in order to weight the frame down for steadier dips or pull ups.

Safety Arms (pair) - The safety arms are constructed from sturdy 2 x 3 x 11 gauge tubing for long lasting durability. Arms are covered with UHMW channel to protect barbells from metal on metal contact. UHMW strips are also located on the inside to prevent metal on metal contact with the uprights, insuring your MDUSA squat stand looks showroom new for years to come!

Dip Attachment - The Dip attachment is a sturdy, easily removable device that gives the ability to do dips without purchasing a separate, stand alone piece of equipment. Constructed from 1-7/8 round tube and powder coated with a textured finish that is easy on the hands.